Facebook Pixel

Multiwatt PHILIPS ballast 35/50/70 Watt

Lieferzeit
2-3 Tage
€70.00
Incl. VAT , plus. Shipping Cost
In stock
SKU
2440

PHILIPS electronic ballast multiwatt 35/50/70 watt - solo without cables

  • For all UVB metal halide lamps 35/50/70 Watt
  • For all gas discharge lamps HQI / HID / HCI / CDM
  • Protected housing unit with strain relief (cable clamp screw fixed)
  • PHILIPS brand product
  • Proven, long service life with maximum allowable temperatures
  • Automatic safety shutdown of lamp defect or at end of life (EOL)

PHILIPS electronic ballast multiwatt 35/50/70 watt

 
  • For all UVB metal halide lamps 35/50/70 Watt
  • For all gas discharge lamps HQI / HID / HCI / CDM
  • Protected housing unit with strain relief (cable clamp screw fixed)
  • PHILIPS brand product
  • Proven, long service life with maximum allowable temperatures
  • Automatic safety shutdown if lamp defect or at end of life (EOL)
  • Weight 320g complete

FAQs: Here you will find frequently asked questions about terrarium UV lamps:

Frequently asked questions about UV lamps

Thermal behavior
 
Due to lamp heat radiation heat accumulation can occur in a closed room. Therefore, it is necessary to ensure that even under adverse conditions, the temperature at the tc-measuring point of the ballastis not exceeded.
 
Attention!
 
  • According to the safety regulations the device is to be disconnected from the mains before lamp replacement!
  • Conductive materials must have 4 mm minimum distance from the terminal strip.
  • Installation only by qualified personnel.
  • Terminals for protective earth not suitable for through wiring.
  • Dimensions: 19 x 8.5 x 3.5 cm
  • Color: gray, dark grey
 
 
Technical details:
 
Energy Efficiency Index EEI: A2
Supply voltage: 220 ... 240 V
Frequency: 50 ... 60 Hz
Interference suppression: to EN 55015 / CISPR 15
Safety: EN 61347-2-12 by
In line with EN 61000-3-2 and EN 61547

Heat behavior
Due to the loss of ballast power and the heat generated by the lamp, heat can build up in an enclosed space. It is therefore important to ensure that the temperature at the measuring point tc of the electronic ballast is not exceeded even under unfavorable conditions.

Warning!
According to the safety regulations, the device must be disconnected from the mains before changing the lamp!
Conductive materials must have a minimum distance of 4 mm to the terminal block.
Installation only by qualified specialists.
The terminals for protective conductors are not suitable for through-wiring.

More Information
Lieferzeit 2-3 Tage
Write Your Own Review
You're reviewing:Multiwatt PHILIPS ballast 35/50/70 Watt
Your Rating
© 2022 Reptiles Expert